Use the Wilson 2 Way Splitter with F-Female connectors in signal distribution systems to split amplified signal with minimum signal loss. Additional Features •2 way splitter, 700-2500 MHz
•Dimensions: 3.6 x 3.5 x 0.8 in
Wilson Electronics RG11 75 foot extension cable with F-male connectors on both ends. Additional Features
Wilson-SMA-Male-to-N-Male-Connector. This adaptor is used to connect to either a RG58 cable (SMA connector) or LMR400 cable (N connector). Additional Features
Wilson F Female - TNC Male adapter Additional Features • Used to connect a TNC/Female connector to a F/Male connector
Wilson 971111 TNC Male Crimp for RG58 Cable Cable. All the coaxial cables on our site are pre-crimped, so you only need this if you have your own cables, or intend to re-crimp ours. Additional Features • TNC Male crimp for RG58 equivalent cable
Wilson Adapter 359934 MCX to N Female Connects to LMR400 Ultra Low Loss Cable for Longer Runs. Additional Features • MCX to N Female
Wilson 952360 60' LMR-400 Coax Cable is compatible with all 50 Ohm weBoost amplifiers. When used correctly, the LMR-400 cable can be used for cable runs in excessive of 60ft. The cable is light, flexible and weatherproof. Additional Features •...
Wilson 950620 20' White RG6 Low Loss Coax Cable - 20 feet RG-6 coax cables for 75 ohm antennas and amplifiers. This high quality coax cable is quad shielded, 75 ohm and comes with an F (male) connector on each end. Additional Features • 20' white...
Wilson 3 way splitter 75 ohm Additional Features
The Wilson 859993 75 Ohm signal splitter allows you to split the signal from an amplifier to up to 4 internal antennas with negligible signal loss. The splitter covers 700-2300MHz, and so will work with all the amplifiers on our site, as well as any...
The Wilson Surge Protector is an inline surge protector that can be used with amplifiers that use the RG6 cables. This unit is installed inline between the antenna and the amplifier. The protector does not connect directly with the amplifier, and a small...
Wilson 4 Way splitter for 700-2300 MHz splitter w/N female connectors.
When to use splitters: For use in signal distribution systems to split
the amplified signal with minimum signal loss. Equal amounts of signal sent
to multiple antennas for similarly...